On power, yes — all of them. Every one of the 9 portable amplifiers in this database reaches 100 dB SPL on the Shure SE846, which needs 0.04 mW at its 9Ω.
Power is one of three questions and the one that goes wrong least often. The other two — whether the source’s output impedance leaves the frequency response alone, and whether you will hear its noise floor — are answered further down, separately, because a source can pass one and fail another.
The cheapest one that does reach it is the Shanling H2 at $169, which delivers 191 mW into 9Ω — 37 dB of headroom over the 0.04 mW this headphone needs for 100 dB SPL.
100 dB SPL is a peak level, not a listening level. If you listen at 85 dB the same headphone needs 0.00 mW, which is 15 dB less, and the answer above changes for most of the category. The model page has the full ladder.
Under the one-eighth rule the Shure SE846 wants a source below 1.12Ω. Of the 7 portable amplifiers here that publish an output impedance, 6 are under it and 1 are not.
The furthest over is the FiiO Q7 at 1.2Ω, which is 1× the ceiling. Above that threshold the source stops being a volume control and starts being part of the frequency response. The simulator shows what that looks like.
The other 2 publish nothing at all on this, so they are not on either side of that count. This site leaves them blank rather than assuming a figure.
Hiss depends on the source’s own noise floor and on how sensitive the headphone is. At 114.0 dB/mW and 9Ω, the Shure SE846 turns one microvolt of source noise into about 14 dB SPL — and the threshold where that stops being noticeable in a quiet room is around 20 dB SPL.
Of the 5 portable amplifiers here that publish a noise figure, 1 stay below that threshold with this headphone and 4 cross it.
The worst of them is the FiiO Q15, whose published 3.1 µV works out to 24 dB SPL of hiss in these. The hiss calculator takes your own figures.
The remaining 4 publish no noise figure, so they cannot be placed on either side.
| Source | Price | Into 9Ω | Output impedance | Hiss in these | Power verdict |
|---|---|---|---|---|---|
| Shanling H2 | $169 | 191 mW | not published | not published | Comfortable |
| iFi hip-dac 3 | $199 | 79 mW | 1 Ω | not published | Comfortable |
| xDuoo XD05 Bal | $499 | 281 mW | not published | not published | Comfortable |
| iFi xDSD Gryphon | $599 | 90 mW | 1 Ω | not published | Comfortable |
| Shanling H7 | $829 | 127 mW | 1 Ω | 18 dB SPL | Comfortable |
| FiiO Q15 | $440 | 422 mW | 1 Ω | 24 dB SPL | Comfortable |
| Chord Mojo 2 | $650 | 180 mW | 0.06 Ω | 23 dB SPL | Comfortable |
| Chord Hugo 2 | $2595 | 987 mW | 0.025 Ω | 23 dB SPL | Comfortable |
| FiiO Q7 | $750 | 422 mW | 1.2 Ω | 23 dB SPL | Comfortable |
Sorted by how many of the three questions the source answers well, then by price. A blank in a column is a blank in the manufacturer’s own documentation, not a zero.
The Shure SE846 on other categories: USB dongles · Bluetooth receivers · portable players · desktop amplifiers · desktop DAC/amps · audio interfaces.
The Shure SE846 page has every source in the database against this headphone, and the matcher takes your own numbers.