Moondrop Kadenz: how much amplifier do you need?

The Moondrop Kadenz is 35Ω with a sensitivity of 107.4 dB/mW, which is 122.0 dB/V. To reach 100 dB SPL — genuinely loud, louder than most people listen — it needs 0.18 mW, or 80 mV across the drivers.

That puts it in the easy category. A phone, a laptop headphone jack or the cheapest USB dongle will drive it to painful levels. Of the 280 sources in the database, 280 have comfortable headroom. The cheapest portable source that does the job is the Apple USB-C dongle (US) at $9.

Sensitivity here is in dB per milliwatt. Manufacturers often quote dB per volt instead and leave the unit off, which is the single most common reason online calculators give answers that are 10–15 dB wrong. The converter explains the difference.

Moondrop publishes this as 122 dB/Vrms ((@1kHz)) — a figure per volt, not per milliwatt. At 35Ω the two differ by 14.6 dB, so the 107.4 dB/mW above is that published number converted, not a different measurement.

This is the conversion that online calculators skip. Quote the per-volt number as if it were per-milliwatt and this headphone looks 15 dB easier to drive than it is — which is roughly the difference between a dongle being enough and not being enough.

Moondrop prints the impedance as 35Ω±15% (@1kHz), not as a bare number. Everything on this page is calculated with the nominal 35Ω, and the rest of that line is quoted here rather than tidied away, because how a figure is qualified is part of the specification too.

Source: moondroplab.com. How this data was built.

Most people listen between 75 and 85 dB. The 100 dB row is the one worth planning around: it gives you headroom for dynamic peaks without designing your system for a volume that would damage your hearing in under fifteen minutes. The safe listening calculator puts numbers on that.

Every source in the database, judged at 100 dB SPL into 35Ω. “Headroom” is how much power is left over above what the headphone needs — 10 dB means ten times the required power, which is what you want for dynamic peaks.

Hiss. At 122.0 dB/V these are sensitive enough to reveal a source's own noise floor. The noisiest source in the database, the Schiit Vali 2+, would put its hiss at roughly 30 dB SPL in these headphones — clearly audible in quiet passages. The hiss calculator lets you check your own amplifier's noise figure.

Output impedance. At 35Ω these want a source output impedance below 4.38Ω to satisfy the one-eighth rule. 35 of the 280 sources here miss it, the worst being the Bottlehead Crack (OTL kit) at 120.0Ω. Above that threshold the source starts shaping the frequency response. Check yours here.

Or open the comparison tool to put any two models side by side, or browse all 578. Or see every Moondrop headphone in the database, and how much of what this site says about them came from Moondrop’s own documents.