The Audeze LCD-2 Classic is 70Ω at 101.0 dB/mW; the Sennheiser HD 560S is 120Ω at 100.8 dB/mW. This page is only about what they ask of an amplifier — not how they sound, which no specification on either sheet can tell you.
In amplifier terms these two are the same headphone. The gap between what they need for 100 dB is under half a decibel, which is smaller than the step between two clicks of most volume controls.
| Specification | Audeze LCD-2 Classic | Sennheiser HD 560S |
|---|---|---|
| Impedance | 70 Ω | 120 Ω |
| Sensitivity | 101.0 dB/mW | 100.8 dB/mW |
| Sensitivity (voltage) | 112.5 dB/V | 110.0 dB/V |
| Power for 100 dB | 0.79 mW | 0.83 mW |
| Voltage for 100 dB | 0.24 V | 0.32 V |
| Current for 100 dB | 3.4 mA | 2.6 mA |
| Highest source impedance that leaves them alone (one-eighth rule) | 8.75 Ω | 15.00 Ω |
| Sources that reach 100 dB out of 280 | 280 | 280 |
Every source in the database that drives one of them drives the other. On power, the choice between these two changes nothing about what amplifier you need.
17 sources are low enough in output impedance for the Sennheiser HD 560S under the one-eighth rule but not for the Audeze LCD-2 Classic (Zoom AMS-22, Arturia MiniFuse 2, Arturia MiniFuse 1, 14 more).
280 of the 280 sources here reach 100 dB on both. That count is about power only — the output-impedance and hiss lines above are separate questions, and a source can pass this one and fail those.
Each model has a page of its own with the full source list, the hiss estimate and the provenance of every figure above: Audeze LCD-2 Classic and Sennheiser HD 560S. Every figure on this page comes from what Audeze and Sennheiser published, or is derived from it — what Audeze publishes and what Sennheiser publishes, both counted.