Audio-Technica ATH-M70X: how much amplifier do you need?

The Audio-Technica ATH-M70X is 35Ω with a sensitivity of 97.0 dB/mW, which is 111.6 dB/V. To reach 100 dB SPL — genuinely loud, louder than most people listen — it needs 2.0 mW, or 0.26 V across the drivers.

That puts it in the easy category. A phone, a laptop headphone jack or the cheapest USB dongle will drive it to painful levels. Of the 53 sources in the database, 53 have comfortable headroom. The cheapest portable source that does the job is the Apple USB-C dongle (US) at $9.

Sensitivity here is in dB per milliwatt. Manufacturers often quote dB per volt instead and leave the unit off, which is the single most common reason online calculators give answers that are 10–15 dB wrong. The converter explains the difference.

Most people listen between 75 and 85 dB. The 100 dB row is the one worth planning around: it gives you headroom for dynamic peaks without designing your system for a volume that would damage your hearing in under fifteen minutes. The safe listening calculator puts numbers on that.

Every source in the database, judged at 100 dB SPL into 35Ω. “Headroom” is how much power is left over above what the headphone needs — 10 dB means ten times the required power, which is what you want for dynamic peaks.

Hiss. At 111.6 dB/V these are sensitive enough to reveal a source's own noise floor. The noisiest source in the database, the Schiit Vali 2+, would put its hiss at roughly 20 dB SPL in these headphones — clearly audible in quiet passages. The hiss calculator lets you check your own amplifier's noise figure.

Output impedance. At 35Ω these want a source output impedance below 4.38Ω to satisfy the one-eighth rule. 1 of the 53 sources here miss it, the worst being the Schiit Vali 2+ at 6Ω. Above that threshold the source starts shaping the frequency response. Check yours here.

Or open the comparison tool to put any two models side by side, or browse all 316.