iBasso DC07 Pro: power output and what it will drive

The iBasso DC07 Pro is an USB dongle at $199. It delivers 118 mW into 32Ω and 13 mW into 300Ω, which ranks it 203 of 280 for raw power among the sources in this database.

Measured at 100 dB SPL it has comfortable headroom on 493 of the 571 dynamic and planar headphones catalogued here, enough but not generous on 63, only marginal on 9 and not enough power for 6. Power is published at 32Ω; the rest of the table is derived from those figures. Output impedance is not published. Output noise is not published, so the hiss estimate cannot be run.

The manufacturer publishes 118 mW into 32Ω. Everything else in the table above is worked out from those figures, and this table says which is which.

The balanced output is rated separately: 430 mW into 32Ω through the 4.4mm jack.

Derivation holds output voltage steady between and beyond the published loads rather than output power, because that is what an amplifier actually does. The full method is written up here.

Source: ibassousa.com, ibasso.com.

Ordered from easiest to hardest to drive. Headroom is measured at 100 dB SPL, which is louder than almost anyone listens — a small negative number means the source still plays loud, just without reserve for peaks.

These figures come from each manufacturer's own sensitivity rating. A handful of planars — the HiFiMAN Susvara and HE-6se and the Abyss AB-1266 in particular — are widely reported to need far more than their published sensitivity implies, so treat a bare pass on those as optimistic rather than settled.

The manufacturer does not publish an output noise figure for this source, so the hiss estimate that runs on every other page here cannot be run on this one. Rather than substitute a plausible number, this page leaves the question open.

If you know the noise figure from a measurement you trust, the hiss calculator takes it directly and tells you where that noise lands in your own in-ears.

The manufacturer does not publish an output impedance for this source. That is the one number that decides whether it leaves your headphones alone or acts as a tone control, so its absence matters more than it looks: without it, nothing here can tell you how this source will behave with a multi-driver in-ear.

If you find a measured figure you trust, the checker will work out the consequence for any headphone.

Or put any two side by side in the source comparison tool, or run your own headphones through the amplifier matcher. Or see every iBasso source in the database, and how much of what this site says about them came from iBasso’s own documents.